Descaling; Cleaning - Siemens CT636LE SERIES Instruction Manual

en
Service programmes
F
Important:
Before starting each service program
(Descale, Clean or calc'nClean)
remove the brewing unit, clean as
instructed and replace it
Be careful not to jam the milk tube
when closing the door
After completion of each service
programme, wipe the appliance
immediately with a soft, damp cloth
to remove any residues from the
descaling and cleaning solution It is
possible for corrosion to form under-
neath such deposits
New sponge cloths may contain
salts Salts can cause rust film on
stainless steel and must therefore be
washed out thoroughly before use
Clean the beverage outlet, milk tubes
and connecting piece thoroughly
Specially developed, suitable
descaling and cleaning tablets are
available from retail outlets or from
customer services (see the section
"Accessories")

Descaling

Takes about 21 minutes
■ Press button E
■ Turn the rotary selector to select
"Descale"
■ Press button C Display indi-
cates progress of the programme
■ Empty drip trays and replace
■ Remove water filter(if there is one) and
press C
■ Pour lukewarm water into the empty
water tank up to the "05 l" mark and
then dissolve one Siemens descaling
tablet TZ80002 in it For the TZ60002 you
should always dissolve two tablets
F
If there is not enough descaling
solution in the water tank, you will
be asked to do the following. Refill
using uncarbonated water and press
C again
50
■ Remove the suction pipe from milk
container, wipe it and insert the end of the
suction pipe into the hole on the coffee
grounds container
■ Close the appliance door
■ Place a container with a capacity of
05 litre under the beverage outlet
■ Press button C The descaling
programme will now run for about
19 minutes
■ Remove the container and press
C
■ Rinse the water tank and (if removed)
replace the water filter.
■ Fill the tank with fresh water up to the
"max" indicator
■ Replace the water tank and close the
door
■ Place the container underneath the bev-
erage outlet again
■ Press button C The desca-
ling programme will now run for about
2 minutes and rinse the appliance
■ Remove the container, empty the drip
trays, replace and close the appliance
door
■ Press C The appliance has
finished descaling and is ready for use
again
■ Press E to exit the program

Cleaning

Takes about 5 minutes
■ Press button E
■ Turn the rotary selector to select "Clean"
■ Press button C Display indi-
cates progress of the programme
■ Clean the beverage outlet and replace,
empty the drip trays and replace
■ Open the ground coffee drawer, drop in
a cleaning tablet and close the coffee
drawer again
■ Close the appliance door
■ Place a container with a capacity of
05 litre under the beverage outlet
■ Press button C The cleaning
programme will now run for about
5 minutes