1. Manuals
  2. Brands
  3. Hitachi Manuals
  4. Trimmer
  5. CG 24EC (SL)
  6. Handling instructions manual

Hitachi CG 24EC Handling Instructions Manual

Hide thumbs Also See for CG 24EC:
Table of Contents

Advertisement

Quick Links

Download this manual
Grass Trimmer/Brush Cutter
Model CG 24EC (S) / CG 24ECM (S)
CG 27EC (S) / CG 27ECM (S)
Handling instructions
Note:
Before using this machine, carefully read through these HANDLING INSTRUCTIONS to ensure
effi cient, safe operation. It is recommended that these INSTRUCTIONS be kept readily available as
an important reference when using this machine.
CG24ECM (S)

Advertisement

Table of Contents
loading

Related Manuals for Hitachi CG 24EC

Summary of Contents for Hitachi CG 24EC

  • Page 1 Grass Trimmer/Brush Cutter Model CG 24EC (S) / CG 24ECM (S) CG 27EC (S) / CG 27ECM (S) Handling instructions CG24ECM (S) Note: Before using this machine, carefully read through these HANDLING INSTRUCTIONS to ensure effi cient, safe operation. It is recommended that these INSTRUCTIONS be kept readily available as...
  • Page 2 CG24EC(S) CG24ECM(S) CG27EC(S) CG27ECM(S)
  • Page 4 CG24EC / CG27EC CG24ECM / CG27ECM 0.6 mm...

  • Page 6: Meanings Of Symbols

    MEANINGS OF SYMBOLS NOTE: Some units do not carry them. Symbols WARNING The following show symbols used for the machine. Be sure that you understand their meaning before use. Grass Trimmer / Brush Cutter Priming pump It is important that you read, fully understand and observe the following safety precautions Guaranteed sound power level and warnings.

  • Page 7: Warnings And Safety Instructions

    Guaranteed sound power level LwA by 2000/14/ Vibration level by ISO 22867 WA, Ra(G) hv, eq(R) Rear or Right handle / Equivalent* Racing 2000/14/EC Vibration level by ISO 22867 Uncertainty hv, eq(F) Front or Left handle / Equivalent* Before using your machine •...
  • Page 8 ○ Keep others away when making carburetor adjustments. Do not operate in areas where there are tree roots or ○ Use only genuine HITACHI replacement parts as rocks. recommended by the manufacturer. ○ For respiratory protection, wear an aerosol protection...

  • Page 9: Specifications

    Wear gloves as the extension has a sharp line limiter. WARNING Loosen the bolt (12). Then push the three square tabs on For Hitachi heads, use only fl exible, non-metallic line the guard one by one in order. (Fig. 7) recommended by the manufacturer. Never use wire or wire ropes.
  • Page 10 ○ Use genuine two-cycle oil or use a mix between 25:1 to in your grasp and not allowing it to snap back. (Fig. 15) 50:1, please consult about the mixture ratio to Hitachi 5. When you hear the engine want to start, return choke Authorized Service Centers.

  • Page 11: Maintenance

    (23). the engine and cease use, then contact the nearest WARNING Hitachi Authorized Service Center. A cutting attachment can injure while it continues to spin Air fi lter (Fig. 23) after the engine is stopped or power control is released.

  • Page 12: Selecting Accessories

    Replace the fastening nut if it is damaged and hard to tighten. ○ When replacing blade, purchase one recommended by Hitachi, with a 25.4 mm (one inch) fi tting hole. ○ In the case of a 3 or 4 tooth blade (31), it can be used on either side.
  • Page 13 SELECTING CUTTING ATTACHMENTS Recommended accessories for each model are presented in the table below. For purchases, contact Hitachi Authorized Service Centers. Please check carefully as those accessories not marked with “ ” cannot be attached. ● List of recommended accessories Specifi...

  • Page 14: Troubleshooting

    TROUBLESHOOTING Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult your dealer or the Hitachi Authorized Service Center. Condition Cause Remedy Fill the fuel tank with the correct fuel mix...
  • Page 15 Set the choke lever to START position to stop the engine Engine does not stop Stop switch failure Cease use immediately and contact Hitachi Authorized Service Centers Engine stops when throttle is Idle speed is too low Contact Hitachi Authorized Service Centers...
  • Page 16 Model CG24EC (S) CG24ECM (S) CG27EC (S) CG27ECM (S) 23.9 26.9 — TORCH L7RTC (NGK BPMR7A) (min 2800 – 3200 Idle Max. (min 9900 9,900 (min 7500 (kW) 0.72 0.81 (kg) — / mm) pA, eq (dB(A)) 85 / 3 85 / 3 ISO22868 WA, Ra(M)
  • Page 17 6684764 944458 875769 6698711 6699756 6696184...
  • Page 20 Hitachi Koki Co., Ltd. Shinagawa Intercity Tower A, 15-1, Konan 2-chome, Minato-ku, Tokyo, Japan Code No. E99703312 NA Printed in China...

This manual is also suitable for:

Cg 27ecCg 24ecmCg 27ecmCg 27ecs

Table of Contents