4.3 Updating firmware
4.3.1 Use USB interface to update ATSAMD21G18A
Tools and Software
Micro-USB cable
Software: SAM-BA v2.15
How to program
1) Connect USB to PC, set the jumpers, press the reset button SW1.
Jumper
Number
Status
2) Open device manager to check whether there is USB CDC virtual COM. You should see
the" Bossa Program Port".You need to remember the COM id that will be used in the
following steps.
3) Open SAM-BA, select the COM id, SAMD21_xplained_pro, and then click "Connect ".
Configure the program address, select the bin file (project path given below) and then click
"Send File". <Grid-
EYE\Source\ATSAMD21G18A\ATSAMD21G18A_USB_DUART_DEMO\SAMD21_USB_D
UART_DEMO\Debug\SAMD21_USB_DUART_57600.bin>
User Manual
J12
J9
ON
ON
Grid-EYE Evaluation Kit
J7
J10
ON
ON
J18
ON
28