Connections; Antenna Connections; Installing The Tuner Units - Sony MB-X6 Operating Instructions Manual

Connections

Antenna connections

AN-820A
UHF
Antenna
Antenna
(supplied)
or
Output A
Connect output A or B to a mixer or amplifier.
Notes
• Make sure to use a pair of antennas.
• Make the antenna tips point upward.

Installing the tuner units

Up to six URX-M1 Diversity Tuner Modules (not
supplied) included in the UWP-X1/X2 Wireless
Microphone Package (not supplied) or WRU-806A/806B
UHF Synthesized Tuner Units (not supplied) can be
installed into the MB-X6.
Notes
• Be sure to turn off the MB-X6 before installing the tuner
units.
• Do not touch the connector on the rear panel of the tuner
units.
• Be careful of static electricity when installing the tuner
units.
Installation
1
Loosen the screws at both sides of the front cover, then
slide the front cover downward.
MB-X6
AC power
cord
(supplied)
Output B To AC power
source
2
Hold the screws by the head and pull forward to
remove the front cover.
3
When installing the tuner unit into the tuner slot other
than slot A, push the corresponding blank panel from
the front side of the front cover to remove it.
4
Insert the tuner unit into the slot until you hear a click.
5
Match the six latches with the six holes on the front
panel, then replace the front cover.
6
Tighten the screws on the front cover to secure it to the
front panel of the MB-X6.
11
Connections