Printing Problems - Canon imageRUNNER 2545i Printer Manual

The service call (E730) appears when using the PS functions.
Cause
Remedy

Printing Problems

Printer is not using the font you want.
Cause
Remedy
One edge of the document is cut off.
5
Cause
Remedy
Printer is printing garbled text.
Cause 1
Remedy
Cause 2
Remedy
Cause 3
Remedy
5-4
Identifying and Isolating Problems
A malfunction occurred when using the PS driver.
Restart the machine—turn OFF the machine, wait at least 10 seconds, and then
turn it ON. (See Chapter 6, "Troubleshooting," in the Reference Guide.)
You have specified a font that is not available.
Check whether the font you specified is available with the machine. (See
"Typeface Samples," on p. 6-20 and "Symbol Sets," on p. 6-33.)
You are trying to print something outside the printable area of the page.
Use your software application to adjust the margins of the page. Make sure that
your software application is not trying to print graphics or text outside the
printable area. (See the application software manual.)
The printer selection you made when you set up or installed your software was
incorrect.
Make sure that the correct printer is selected.
If different portions of the text are garbled every time you print, the USB cable
may be too long, causing noise to corrupt the data.
A USB cable of 3 meters or shorter is recommended. If your USB cable is
longer than this, replace it with a shorter one.
The machine is plugged into an outlet shared with another electrical device
capable of generating noise, such as a photocopier, shredder or air conditioner.
Plug the machine into a different outlet or consult a qualified technician to install
a noise filter.