System Setup; Disposal - Siemens SISTORE AX8 500/200 V3.6 Installation Instruction

7.4

System setup

8

Disposal

Siemens Building Technologies
Fire Safety & Security Products
Pressing the
Menu Menu
user and password to access Setup. Pressing the button also closes the current menu or
setup dialog box. In the Playback mode, pressing the Menu button displays the Search
menu. In Search mode clip-copying can be done instantly by pressing and holding the
button for two or more seconds. The button also loads a Preset View in the PTZ mode.
Enter The Enter button selects a highlighted item or completes an entry that you have made
during system setup.
Panic Pressing the
Panic
on the screen. Pressing the button again will stop panic recording. The sensor for the
infrared remote control is just to the lower left of the
nothing blocks the sensor, or the remote control will not function properly.
Power The Power LED is lit when the unit is On.
Network
The Network LED flickers when the unit is connected to a network via Ethernet.
HDD
The HDD LED flickers when the DVR is recording or searching video on the hard disk
drive.
The front panel buttons are used to enter system commands and for programming.
Press button on the front panel and enter the password by pressing the
Menu
appropriate combination of Camera number buttons and then the Enter button.
Refer to User Manual for the setup instructions in detail. The documentation is
located on the CD or in the application folder on the PC hard disk (C:\SISTORE
AX\...).
Setup menu
All electrical and electronic products should be disposed of separately from the
municipal waste stream via designated collection facilities appointed by the
government or the local authorities.
This crossed-out wheeled bin symbol on the product means the product is covered by
the European Directive 2002/96/EC.
The correct disposal and separate collection of your old appliance will help prevent
potential negative consequences for the environment and human health. It is a
precondition for reuse and recycling of used electrical and electronic equipment. For
more detailed information about disposal of your old appliance, please contact your
city office, waste disposal service or the shop where you purchased the product.
button enters the Setup screen. You will need to enter the authorized
button starts panic recoding of all camera channels, and displays
Disposal
button. Make certain that
Panic
12.2008
13
EN