Health and Safety guide SAFETY INSTRUCTIONS IMPORTANT TO BE READ AND OBSERVED This dryer is suitable for All safety warnings give removers, turpentine, waxes domestic use, not suitable for specific details of the potential and wax removers should be the outdoor use . risk presented and indicate washed in hot water with an how to reduce risk of injury,...
Page 6
detergent - this will reduce, but or use gasoline or other been completed . not eliminate, the hazard . flammable materials in or near the dryer: a fire may break out After installation of the device WARNING if the dryer is inadvertently to wait a few hours before switched on .
Page 7
of each drying cycle, since the multiple sockets or adapters . condensation water can be Do not connect the dryer to a directly drained away . socket which can be operated by remote control . Take care not to install the The power cable must be long dryer on a deep-pile carpet .
CORRECT USE used for cleaning . CLEANING AND MAINTENANCE Do not exceed the maximum Do not overdry the laundry . load allowed . Check the The dryer must be maximum load allowed in the Take care that no lint or dust is disconnected from the power programme chart .
ENERGY SAVING TIPS ly requires less energy . You will When drying cotton, for exam- save time and energy when ple, dry Iron Dry and Cupboard Always dry a full load, depend- running your drying cycle . Dry loads together . Start with ing on the type of laundry and the Iron Dry programme/dry- the programme/drying time .
Use and Care guide PRODUCT DESCRIPTION APPLIANCE 1. Worktop 2. Control panel 3. Water tank 4. Door 5. Door handle 6. Door filter (behind door) 7. Bottom filter (behind flap) 8. Adjustable feet (4) CONTROL PANEL 1. On/Off button (Reset if long pressed) 2.
DOOR To open the door, pull the handle . To close the door, hold the handle and push so that you can hear it click shut . If you interrupt a running programme by opening the door, the programme will be reset if the dryer door is not closed again within one minute .
HOW TO USE THE APPLIANCE FIRST TIME USE CHECK WATER TANK Make sure that the water tank is correctly inserted CHECK DRAIN HOSE Make sure that the drain hose on the back of the dryer is fixed, either to the dryer’s water tank or to your domestic sewage system (see INSTALLATION GUIDE) .
DAILY USE Make sure that no lighters Make sure that the or matches are left in laundry is not soaked with WARNING clothing. flammable liquids. LOAD THE LAUNDRY you through setting your programme in the Respect your items’ care labels; make sure following order: selection of programme / that the items to be dried are suitable for drying time (ONLY if Drying time or Airing...
Page 14
Set dryness level, if needed • Adjust drying time (only if programme If you want to change the dryness level, make Drying time or Airing is selected) sure that the Dryness level button « lights up . • Adjust or cancel Start delay, if a delay option is already in progress .
end, the dryer will tumble the laundry for • the door filter after each programme about 10 minutes, to prevent creasing . The • the bottom filter after every fifth display shows an animation . programme . Refer to section CARE AND MAINTENANCE EMPTY WATER TANK / CLEAN DOOR FILTER / CLEAN BOTTOM FILTER Empty...
Page 16
PROGRAMME Type of Wash Care Regulations and Recommendations Labels SYNTHETICS ): 3.5 For drying laundry made of synthetic load fibres . default programme ): 1:00 duration selectable options Steam option, Dryness level, Fresh care, Gentle DELICATES For drying delicate laundry which ): 2.5 load needs gentle treatment .
PROGRAMME Type of Wash Care Regulations and Recommendations Labels STEAM REFRESH ): 1.5 For refreshing laundry with steam . load Specifically designed to refresh and default programme ): 0:30 remove odours from dry and duration clean casual garments like shirts, selectable options blouses, trousers made out of cotton, synthetics and their blends .
OPTIONS OPTIONS WHICH ARE DIRECTLY SELECTABLE BY PRESSING THE RESPECTIVE BUTTON STEAM OPTION Minimises creasing of garments made immediately after programme end of cotton, synthetics and their blends and put them on clothes hangers . by adding a humidifying phase at the end of the drying cycle .
FUNCTIONS ON/OFF To switch the dryer on: press the To cancel a running programme: button until the Start/Pause button press and hold the button until “rES” lights up . appears on the display . To switch the dryer off after programme end: press the button until the lights go off .
Page 20
The programme starts automatically the default programme duration . at the end of the delay period . On To cancel a delay which has already programme start, the delay on the been started: display is replaced by the remaining programme duration . Either press Start/Pause to cancel the delay .
INDICATORS WATER TANK FULL => empty water tank BOTTOM FILTER CLOGGED => clean bottom filter DOOR FILTER CLOGGED => clean door filter FAILURE For any failure indication on the display, refer to section TROUBLESHOOTING for more information . Find more information in section CARE AND MAINTENANCE, and TROUBLESHOOTING GUIDE .
ENERGY SAVING AUTOMATIC SWITCH-OFF FUNCTION The dryer is designed to save energy . After the programme has finished, it therefore switches off automatically after about a quarter of an hour . ENERGY SAVING TIPS • The optimum ambience temperature for the dryer is between 15 and 20 °C .
CLEANING & MAINTENANCE Do not use flammable fluids WARNING to clean the dryer. For any cleaning and maintenance, switch off the dryer . EMPTYING THE WATER TANK Empty the water tank after each programme, provided the drain hose is not connected to your sewage system (refer to INSTALLATION GUIDE) .
CLEANING THE DOOR FILTER Clean the door filter after each programme . Carefully remove the complete lint from the Make sure that the laundry is unloaded . Open the screen by hand . door . If needed, the screen can be cleaned also under running water, using a soft brush .
CLEANING THE BOTTOM FILTER Clean the bottom filter after every fifth programme . Clean the filter foam and the filter by hand or under running water . Do not wash the filter foam in Open the bottom flap . the washing machine . Hold the handle and pull out the bottom filter .
Page 26
Insert the bottom filter again . Make sure that it Close the bottom flap . is completely integrated in the filter compartment . Clap the filter handle downwards .
CLEANING THE OUTSIDE OF THE DRYER Use a soft damp cloth to clean the outer parts of the dryer . Do not use glass or general purpose cleaners, scouring powder or similar to clean the control panel – these substances might damage the surfaces .
REVERSING THE DOOR STOP If needed, the door stop of the dryer door can be For removing and fixing the door, the help of a reversed . Use pliers and a cross-head screwdriver for second person is recommended . Make sure that the the procedure .
Page 29
Unscrew the bottom screw, to release the Carefully turn the door frame in clockwise cover frame on the front of the door . direction, and remove it . Turn the door again and lay it upside down . Turn the door and lay it down on the door glass .
Page 30
Remove the two side screws . Do this on both Remove the side parts on each side of the sides of the door . door . Reverse the side parts and insert them again . Remove the 4 inner screws on each side of the door .
Page 31
Fix the 2 side screws on both sides of the Turn the door and lay it down on the door door again . glass . Fix the 4 inner screws on each side again . Refit the door frame .
Page 32
Turn the door again and lay it upside down . Fix the two screws over and under the door Fix the bottom screw again . lock, on the right side of the door opening . Fix the door on the left side of the door opening by turning in the two screws .
TROUBLESHOOTING GUIDE & AFTER-SALES SERVICE Your dryer is equipped with various automatic safety functions . These enable failures to be detected in good time and the safety system can react appropriately . These failures are frequently so minor that they can be removed within a few minutes .
Page 34
Problem Possible Cause Solution WATER DROPLETS ARE Bottom filter not inserted • Check position of the bottom BENEATH THE DRYER correctly filter and make sure it is completely integrated in the filter compartment . Lint remaining on bottom filter or •...
FAILURE INDICATOR AND MESSAGES Make sure to • Empty the water tank after each programme • Clean the door filter after each programme • Clean the bottom filter after every fifth programme Failure Indicator Possible Cause Solution Water tank may be •...
Page 36
Below is a summary of possible failure causes and solutions . If the problem persists after having followed the instructions as indicated below, press and hold On/ Off for at least three seconds . If afterwards the failure indication still appears, switch off and unplug the dryer and contact our After-Sales Service .
TRANSPORT AND HANDLING Never lift the dryer by WARNING holding it at the worktop. Unplug the dryer . If the drain hose is connected to your sewage system, fix the drain hose on the rear of the dryer again (see Installation Guide) . Make sure that door and water tank are properly closed .
• your full address; • your telephone number . For any repairs, use our authorized After-Sales Service, to ensure proper repairing and use of original spare parts . Manufacturer: Whirlpool Europe s.r.l. Socio Unico Viale Guido Borghi 27 21025 Comerio (VA) Italy...