INSTRUMENT AND CONTROL FUNCTIONS
3
1. Traction control system mode display
1. Traction control system switch "TCS"
Resetting
The traction control system may be dis-
abled in the following conditions:
●
Either the front wheel or rear wheel
comes off the ground while riding
●
Excessive rear wheel spinning
If the traction control system has been
disabled, both the traction control sys-
1
tem indicator/warning light and the en-
gine trouble warning light come on.
To reset the traction control system:
Turn the key to "OFF". Wait at least one
second, then turn the key back to "ON".
The traction control system indica-
tor/warning light should go off and the
system will be enabled. The engine
trouble warning light should go off after
1
the motorcycle reaches at least 20
km/h (12 mi/h). If the traction control
system indicator/warning light and/or
engine trouble warning light still remain
on after resetting, the motorcycle may
still be ridden; however, have a
Yamaha dealer check the motorcycle
as soon as possible.
NOTICE
●
Keep any type of magnets (in-
cluding magnetic pick-up tools,
magnetic
away from the front wheel sen-
sor or rotor; otherwise, the sen-
sor or rotor may be damaged,
1. Front wheel sensor rotor
2. Front wheel sensor
ECA17731
screwdrivers,
etc.)
3-23
resulting in improper perfor-
mance of the traction control
system.
●
Be careful not to damage the
sensor or rotor.
1
2