Maintenance; Greasing The Brush - Toro 30426 Operator's Manual

Maintenance

Note: Determine the left and right sides of the machine
from the normal operating position.

Greasing the Brush

The rotary brush must be lubricated regularly. If machine is
operated under normal conditions, lubricate bearings and
bushings with No. 2 general purpose lithium base grease
after every 8 hours of operation or daily, whichever comes
first. Lubricate fittings immediately after every washing.
The rotary brush has (12) fittings that must be lubricated
(Fig. 19).
• Castor shaft bushings (2)
• Axle shaft bearings (2)
• Right and left lift arms (2)
• Right and left brush arms (4)
• Pivot pin (1)
• Cylinder pivot (1)
Figure 19
14