Figure 23
Oil Drive Chain
(Model 07052)
Oil entire length of all chains every 30 hours of operation
with SAE 30 oil.
Figure 24
Oil Sweeper Jack
Sweeper jack must be oiled after every 50 hours of
operation.
Figure 25
Changing Engine Oil and Filter
(Model 07050 only)
Change oil initially after the first 5 hours of operation,
thereafter change oil every 100 hours and filter every 200
hours.
1. Park the machine on a level surface and turn the engine
off.
2. Remove drain plug and let oil flow into drain pan.
When oil stops, install drain plug.
Note: Warm oil flows better and carries more contaminants
than cold oil.
3. Remove oil filter. Apply a light coat of clean oil to the
new filter gasket.
1. Drain plug
4. Screw filter on by hand until gasket contacts mounting
plate, then tighten 1/2 turn further. DO NOT
OVER–TIGHTEN.
5. Add oil to crankcase, refer to Check Engine Oil.
6. Dispose of used oil properly.
18
2
1
Figure 26
2. Oil filter