Operating Instructions - Electrolux EXD25DN3W User Manual

OPERATING INSTRUCTIONS

Allow the unit to reach room temperature
before operating. To begin operating the
dehumidifier, follow these steps:
Unit must be upright for one hour prior to
operating.
1. Plug the power cord into a properly
grounded 220 V AC outlet.
If the BUCKET FULL light is on,
remove the bucket and re-install to
reset the float switch.
2. To turn the unit on, press the ON/
OFF button
factory setting of CONTINUOUS and
high fan speed. In the CONTINUOUS
mode, the unit will only display CO
and not the room humidity. It is
recommended you leave the unit
running in the CONTINUOUS setting
for the first three or four days until the
sweating and dampness odors have
stopped.
3. After a few days when the Relative
Humidity has declined, press the
HUMIDITY
choose a value between 35% to 85%,
so the room is kept at a comfortable
humidity. Pressing the
buttons will change the humidity
selection in 5% increments.
After you have set the desired
humidity, the readout will display
the actual room humidity. If at any
time you want to return to the
CONTINUOUS Mode, pressing the
HUMIDITY
Relative Humidity through the 5%
increments until the display reads CO.
. The unit will run in the
or buttons to
or
button will lower the
4. You can also use the FAN SPEED
button to change the fan speed to
HIGH or LOW. The indicator light will
show the setting you have selected. A
higher fan speed will result in quicker
moisture removal.
5. The CLEAN FILTER light will illuminate
after 250 hours of operation. At this
time refer to the care and cleaning
section to remove and clean the filter.
Once the filter has been cleaned and
replaced, simply press the FILTER
button to extinguish the light.
6. The TIMER function enables you to
either Delay Start or Delay Stop the
unit in the choice from 0.5 hour to
24 hours. If the unit is running, then
selecting Timer will turn the unit off in
the hours that will be set (Delay Stop).
If the unit is off, then selecting Timer
will turn the unit on in the hours that
will be set (Delay Start).
TIMER setting:
First press TIMER button
adjust timer setting, by tapping
or holding the
change the delay timer at 0.5 hour
increments, up to 10 hours, then by
1 hour increments up to 24 hours.
The control will count down the time
ENGLISH 5
, then
or button to