Connecting The Transmitter Battery - Toro EZ-Remote User Manual

Connecting the Transmitter Battery

1. Press the top edge of the access cover in and down to remove.
2. Remove the battery and the insulation tape from the battery terminals.
3. Attach the battery clip, insert the battery into the transmitter and install the access cover.
Important: When replacing the battery, use only an equivalent 9V alkaline type. Properly dis-
pose of the used battery as recommended by the battery manufacturer.
Installing the Receiver Indoors (Refer to Figure 2)
1. Using two wood screws supplied (and drywall screw anchors as necessary), secure the receiver
plug bracket to the wall within 3' (0.9 m) of the controller and at least 3' (0.9 m) above the floor.
Note: A 25' (7.6m) receiver cable kit is available. Order part number EZR-CA25.
Note: Receiver reception can be impaired if the receiver is installed less than 3' (0.9 m) above the
floor.
2. Install the receiver plug assembly to the receiver plug bracket orienting the D-shaped slot as shown.
Caution: Ensure the controller and receiver plug assembly are securely fastened to the
wall before connecting the cable to the controller.
3. With the receiver lock up, install the receiver to the plug and slide the lock down to secure.
4. Plug the cable connector into the GreenKeeper 212 receptacle as shown.
5. Straighten the antenna wire so it extends vertically from the top of receiver.
Caution: The controller phone jack receptacle is for connection of the EZ-Remote
receiver cable only. Do not connect a telephone or modem line to this receptacle.
2