G Misfeed In The Saddle Stitch Finisher; Misfeed In The Saddle Stitch Finisher - Sharp AR-C260P Operation Manual

Misfeed in the saddle stitch finisher

When a misfeed occurs in the saddle stitch finisher, remove the misfed paper as follows.
1 Unlatch the saddle stitch finisher and slide
it away from the main unit.
2 Remove the misfed paper from the main
unit.
If misfed paper is not found in step 1, open
3
the top cover.
4 If the punch unit is installed, remove the
misfed paper by pulling the paper while
turning roller knob B.
After removing the
misfed paper, open and
close the duplex
bypass/inverter to reset
the jam indicator. (See
"Misfeed in the Fusing
area" steps 1 and 4 on
page 2-25.)
Take care not to tear the
paper.
Roller knob B
SADDLE STITCH FINISHER
5 Close the top cover.
If saddle stitching was selected, open the
6
front cover.
Turn roller knob C as shown in the
7
illustration until the blue indicator is
visible.
Roller knob C
Blue
8 Remove the misfed paper from the stapler
compiler.
Open the saddle stitch section cover.
9
Be careful not to tear the
misfed paper during
removal.
5-7
5