Siemens SINUMERIK 840D sl Programming Manual page 18
Measuring cycles hmi sl
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
General
1.4 Reference points on the machine and workpiece
SINUMERIK controls use numerous frames: various basic frames, system frames, settable
frames (e.g. G54), programmable frames: They interact in a frame chain to produce the
overall frame and the workpiece coordinate system.
Measuring cycles do not support any frames with an active scale factor. Rotation or mirroring
is not supported in some cycles and measuring variants.
The machine and workpiece coordinate system can be set and programmed separately in
the "inch" or "metric" measuring system.
Note
Transformation
If kinematic transformation is active, the control makes a distinction between the basic
coordinate system and machine coordinate system.
If kinematic transformation is deactivated, this distinction is made.
All descriptions provided below assume that kinematic transformation is deactivated and
therefore refer to the machine coordinate system.
18
Programming Manual, 03/2009 Edition, 6FC5398-4BP10-2BA0
Measuring cycles
Advertisement
Table of Contents
