Hitachi CG 18DSDL Handling Instructions Manual page 45

○ Appropriate Length of Nylon Line
The appropriate length of the line when the
tool is in use is 90 – 110 mm. Extend the
line to the appropriate length.
4. Nylon line replacement
(1) Prepare φ1.4 mm × 6 m of genuine nylon
line (Code No.333923).
(2) Press the opposing tabs, and then remove
the cover from the case. (Fig. 14)
(3) Remove the reel from the case. (Fig. 15)
○ If there is nylon line remaining, hook the line
in the groves, and then remove the reel.
○ If the nylon line does not extend when there
is enough nylon line remaining, or when
replacing the nylon line (Code No.333923),
wind the nylon line using the following
procedure.
(4) As shown in Fig. 16 and 17, draw the nylon
line through the hole of the reel and hook it in
the groove of the reel, and then wind the line
in the direction of the arrow so that the nylon
line does not cross.
(5) Leave about 100 mm – 150 mm nylon cord
unwound, hook and secure the line in the
stopper. (Fig. 18)
NOTE
Do not cross the nylon line when securing the
line in the stopper. (Fig. 19)
Groove
Secure in
the stopper
Fig. 18
45
English
Cover
Hook
Press tabs
(2 areas)
Case
Fig. 14
Groove
Reel
Fig. 15
Reel
Hole of
reel
Nylon line
Direction to
wind nylon cord
Fig. 16
Nylon
Reel
line
Direction to
wind nylon cord
Fig. 17
Fig. 19