Storage; Cleaning And Storage - Toro 74311TE Operator's Manual

Storage

Cleaning and Storage

1. Disengage the power takeoff (blade-control switch
(PTO), set the parking brake, and turn the ignition key
to the O position. Remove the key.
FF
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially the
engine and hydraulic system. Clean dirt and chaff from
the outside of the engine cylinder head fins and blower
housing.
Important: You can wash the machine with mild
detergent and water. Do not pressure wash the
machine. Avoid excessive use of water, especially
near the control panel, engine, hydraulic pumps,
and motors.
3. Check the brake; refer to
(page 18).
4. Service the air cleaner; refer to
Cleaner (page 33).
5. Grease the machine; refer to
(page 30).
6. Change the crankcase oil; refer to
Oil (page 36).
7. Check the tire pressure; refer to
Pressure (page 42).
8. Change the hydraulic filters; refer to
Hydraulic Filter (page
9. Charge the battery; refer to
40).
10. Scrape any heavy buildup of grass and dirt from the
underside of the mower, then wash the mower with
a garden hose.
Note: Run the machine with the blade control switch
(PTO) engaged and the engine at high idle for 2 to
5 minutes after washing.
11. Check the condition of the blades; refer to
the Blades (page 53).
12. For storage over 30 days, prepare the machine as
follows:
A. Add a petroleum-based stabilizer/conditioner to
fuel in the tank. Follow the mixing instructions
from the stabilizer manufacturer. Do not use an
alcohol-based stabilizer (ethanol or methanol).
Note: A fuel stabilizer/conditioner is most
effective when mixed with fresh fuel and used at
all times.
B. Run the engine to distribute conditioned fuel
through the fuel system (5 minutes).
Operating the Parking Brake
Servicing the Air
Greasing the Machine
Changing the Engine
Checking the Tire
Replacing the
51).
Charging the Battery (page
Inspecting
C. Shut off the engine, allow it to cool, and drain the
fuel tank; refer to
39).
D. Start the engine and run it until it stops.
E. Dispose of fuel properly. Recycle as per local
codes.
Important: Do not store
stabilizer/conditioned fuel over 90 days.
13. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged.
14. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
15. Store the machine in a clean, dry garage or storage area.
Remove the key from the ignition switch and keep it
out of reach of children or other unauthorized users.
Cover the machine to protect it and keep it clean.
58
Servicing the Fuel Tank (page