Adjusting The Control Lever Neutral Return - Toro 30695 Operator's Manual

Figure 45
1. Control lever
2. Neutral interlock switch
4. Holding the control lever against the frame, move the
switch toward the lever until the distance between lever
and switch body is 0.4 to 1 mm (0.015 to 0.045 inch )
(Figure 45).
5. Secure the switch.
6. Repeat steps 3 to 5
7. Install the front panel.
Adjusting the Control Lever
Neutral Return
If the motion control levers do not align with the neutral slots
when released from the reverse drive position, adjustment is
required. Adjust each lever, spring, and rod separately.
1. Disengage the PTO, move the control lever to the
neutral locked position, and set the parking brake.
2. Move the throttle lever to the Slow position, stop the
engine, remove the key, and wait for all moving parts to
stop before leaving the operating position.
3. Remove the bolts securing the front panel and remove
the panel (Figure 46).
3. Screws
4. 0.4 to 1 mm (0.015 to
0.045 inch )
for the other lever.
2
1
1. Bolts
2. Control panel
4. Move the control lever to the neutral position but not
locked (Figure
5. Pull the lever back until the clevis pin (on an arm
above the pivot shaft) contacts the end of the slot (just
beginning to put pressure on the spring)
1. Clevis pin
2. Slot
3. Jam nuts
6. Check where the control lever is relative to notch in
console (Figure
Note: It should be centered allowing lever to pivot
outward to the neutral lock position.
43
G020875
Figure 46
48).
(Figure
Figure 47
4. Adjustment bolt
5. Yoke
48).
47).