Drive System Maintenance; Checking The Seat Belt; Checking The Knobs On The Rollover Protection System (Rops) - Toro 74906 Operator's Manual

4. Connect the other end of the positive cable to the
positive terminal of the booster battery.
5. Connect the black negative (–) cable to the other
terminal (negative) of the booster battery.
6. Make the final connection on the engine block of
the stalled vehicle (not to the negative battery post)
away from the battery and stand back
Figure 63
1
2
Figure 64
1. Engine block
7. Start the vehicle and remove the cables in the
reverse order of connection (the engine block (black)
connection is the first to disconnect).
(Figure 64).
G008804
g0131 17
2. Negative (–) cable
Drive System
Maintenance

Checking the Seat Belt

Service Interval: Before each use or daily
Visually inspect seat belt for wear, cuts, and proper operation
of retractor and buckle. Replace before operating if damaged.
Checking the Knobs on the
Rollover Protection System
(ROPS)
Service Interval: Before each use or daily
WARNING
To avoid injury or death from rollover: keep the roll
bar in the fully raised locked position and use the
seat belt.
Ensure that the rear part of the seat is secured with
the seat latch.
Check that both the mounting hardware and the knobs are
in good working condition. Make sure the knobs are fully
engaged with the ROPS in the fully raised position. The
upper hoop of the roll bar may need to be pushed forward or
pulled rearward to get both knobs fully engaged.
44