Premaintenance Procedures; Pre-Maintenance Safety - Toro 31200 Operator's Manual

Notation for Areas of Concern
Inspection performed by:
Item
CAUTION
If you leave the key in the ignition switch, someone could accidently start the engine and seriously injure
you or other bystanders.
Remove the key from the ignition before you do any maintenance.
Premaintenance
Procedures

Pre-Maintenance Safety

•
Keep all parts of the machine in good working condition
and all hardware tightened, especially blade-attachment
hardware. Replace all worn or damaged decals.
•
Never allow untrained personnel to service the machine.
•
Before adjusting, cleaning, or repairing the machine, do
the following:
1. Move the machine to level ground.
2. Disengage the drives.
Date
Figure 22
Service Interval Chart
3. Lower the cutting units.
4. Move the traction pedal to the N
5. Engage the parking brake.
6. Move the throttle switch to the
7. Shut off the engine and remove the key.
8. Wait for all moving parts to stop.
•
Whenever you park or store the machine, or leave it
unattended, lower the cutting units unless you use a
positive mechanical lock.
•
If possible, do not perform maintenance on the machine
while the engine is running. If you must run the engine to
perform maintenance on the machine, keep your hands,
feet, other body parts, and clothing away from all moving
28
Information
position.
EUTRAL
- position.
LOW IDLE