Table of Contents
Advertisement
1. Roll bar
2. Pin
4
Checking the Tire Pressure
No Parts Required
Procedure
The tires are over inflated for shipping. Therefore, release
some of the air to reduce the pressure. The correct air
pressure for non-cab models is 103 kPa (15 psi) in the front
tires and 172 kPa (25 psi) in the rear tires. If a cab is installed
on the machine, the front and rear tires should be inflated to
172 kPa (25 psi).
5
Checking the Fluid Levels
No Parts Required
Procedure
1. Check the hydraulic fluid level before starting the
engine, refer to Checking the Hydraulic Fluid Level in
the Maintenance Section.
2. Check the engine oil level before starting the engine,
refer to Checking the Engine Oil Level in the
Maintenance Section.
3. Check the cooling system before starting the
engine; refer to Checking the Cooling System in the
Maintenance Section.
Figure 5
3. Hairpin cotter pin
Product Overview
Controls
Become familiar with all the controls before you start the
engine and operate the machine.
Traction Pedal
The traction pedal (Figure 6) controls the forward and reverse
operation. Press the top of the pedal to move forward and the
bottom to move rearward. Ground speed depends on how
far you press the pedal. For no load, maximum ground speed,
fully press the pedal while the throttle is in the Fast position.
To stop, reduce foot pressure on the traction pedal and allow
it to return to the center position.
Note: For emergency stops, press the rear of the traction
pedal (reverse) to stop the machine quickly.
1. Parking brake
2. Brake pedal
3. Tilt steering pedal
Speed Limiter
The speed limiter lever (Figure 6) can be flipped forward to
limit the traction speed while operating.
Brake Pedal
The brake pedal is used in conjunction with the brake pedal
latch to engage and disengage the parking brake (Figure 6) To
stop the machine, release the traction pedal and allow it to
return to the center position. The brake can assist in stopping
in an emergency situation.
16
Figure 6
4. Traction pedal
5. Speed limiter
Advertisement
Table of Contents
