Servicing The Battery - Toro 72200 Operator's Manual

2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Open the hood. Pull wire connectors off both bulb
holder terminals.
4. Rotate the bulb holder 1/4 turn counterclockwise and
remove it from the reflector (Fig. 30).
5. Push and rotate the bulb counterclockwise until it stops
(approx. 1/4 turn) and remove bulb from the bulb
holder (Fig. 31).
5
3
2
4
Figure 30
1. Bulb holder
2. Reflector
3. Tabs
Installing the Bulb
1. The bulb has metal pins on the side of its base. Align
the pins with the slots in the bulb holder and insert the
base into the holder (Fig. 31). Push and rotate the bulb
clockwise until it stops.
5
1
4
4. Slots
5. Terminals
29
2
4
3
Figure 31
1. Bulb
2. Metal pins
2. The bulb holder has two tabs (Fig. 30). Align the tabs
with the slots in the reflector, insert the bulb holder
into the reflector and rotate it 1/4 turn clockwise until
it stops.
3. Push the wire connectors onto the terminals on the
bulb holder.

Servicing the Battery

Warning
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals
known to the State of California to cause cancer
and reproductive harm. Wash hands after
handling.
Service Interval/Specification
Always keep the battery clean and fully charged. Use a
paper towel to clean the battery case. If the battery
terminals are corroded, clean them with a solution of four
parts water and one part baking soda. Apply a light
coating of grease to the battery terminals to prevent
corrosion.
Voltage: 12 v, 260 Cold Cranking Amps
1
2
4
3. Bulb holder
4. Slots