Adjusting The Roller Scraper (Optional); Installing The Mulching Baffle (Optional) - Toro 30807 Operator's Manual

10
Adjusting the Roller Scraper
(Optional)
No Parts Required
Procedure
The optional rear roller scraper is designed to work best
when there is an even gap of 0.5 to 1 mm (0.020–0.040 inch)
between the scraper and roller.
1. Loosen the grease fitting and the mounting screw
(Figure 19).
Figure 19
1. Roller scraper
2. Mounting screw
2. Slide the scraper up or down until a gap of 0.5 to 1
mm (0.020 to 0.040 inch) is achieved between the rod
and the roller.
3. Secure the grease fitting and screw to 41 N-m (30 ft-lb)
in an alternating sequence.
11
Installing the Mulching Baffle
(Optional)
No Parts Required
Procedure
1. Thoroughly clean debris from the mounting holes on
the rear wall and left side wall of the chamber.
2. Install the mulching baffle in the rear opening and
secure it with 5 flange head bolts (Figure 20).
1
2
3
3. Grease fitting
1. Mulching baffle
3. Verify that mulching baffle does not interfere with
the tip of the blade and does not protrude inside the
surface of the rear chamber wall.
WARNING
Do not use the high lift blade with the
mulching baffle. The blade could break,
resulting in personal injury or death.
G011346
22
1
G011347
Figure 20