Filling The Fuel Tank; Stopping The Engine; Starting The Engine - Toro Snow Commander 38600 Operator's Manual

Hide thumbs Also See for Snow Commander 38600:
Table of Contents

Advertisement

4. Shake the container to mix the gasoline and oil
thoroughly.
5. Slowly remove the cap and add the remaining amount
of gasoline.
Note: Do not mix gasoline and oil in the fuel tank. Oil
at room temperature mixes easier and more thoroughly
than cold oil. Oil below 32°F (0°C) requires additional
mixing.

Filling the Fuel Tank

Fill the fuel tank with a fresh mixture of gasoline and oil
mixed at the proper ratio (Figure 10).
Figure 10
1. 1/2 inch (1.3 cm)

Starting the Engine

1. Turn the ignition key clockwise to the On position
(Figure 11).
Figure 11
2. Move the choke lever to the right (Figure 12).
Figure 12
3. Firmly push in the primer 2 times with your thumb,
holding the primer in for a second before releasing it
each time (Figure 13).
Figure 13
4. Pull the recoil starter (Figure 14).
Figure 14
5. With the engine running, move the choke lever to the
left slowly.

Stopping the Engine

To stop the engine, turn the ignition key counterclockwise
to the Off position (Figure 15).
Figure 15
8

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents