Electrical System Maintenance; Fuses - Toro 31598N Operator's Manual

6. Operate the water separator priming pump until a solid
stream of fuel is detected at the banjo fitting
66).
7. Tighten the fuel filter banjo fitting.
8. Push down the priming pump and turn it clockwise
to secure.
9. Start the engine and check for fuel leaks around the
filter head.
Electrical System
(Figure
Maintenance
WARNING
If installing an auxiliary accessory to the machine,
the only approved locations to source power are
the traction unit fuse block
fuse block
available from either location. Contact your local
Toro distributor for assistance.
Note: Make sure the key is off and removed from the switch
before removing fuses.

Fuses

The traction unit fuses
center console
1. Power center console
47
(Figure
(Figure 71). A maximum of 10 amps is
(Figure 69) are located in the power
(Figure 68).
Figure 67
Figure 68
2. Knob
69) or the cab
g021 155