Setup; Loose Parts; Installing The Rear Wheels - Toro 09802 HydroJect 3010 Operator's Manual

Setup

Note: Determine the left and right sides of the machine from the normal operating position.

Loose Parts

Note: Use this chart as a checklist to ensure that all parts have been received. Without these parts, total setup cannot be
completed.
Description
Wheel
Lug nut
Ignition key
Hose adapter
Spanner wrench
Parts catalog
Operator's manual

Installing the Rear Wheels

1. Remove the wheels from the shipping pallet.
2. Mount the wheels to the hubs with the lug nuts
(supplied in loose parts) (Fig. 1) and torque the nuts to
45–55 ft.-lb. (61–75 N⋅m).
3. Remove any shipping blocks or braces, which may
obstruct machine removal from the pallet.
Important Refer to the Before Operating section in this
manual, page 13, for instructions on preparing the machine
for operation.
Qty. Use
3
Installing the rear wheels
12
1 Use in ignition switch.
1 Mount to quick coupler on side of machine.
1 Use for installation and removal of water filter.
1
1 Read before operating the machine.
1. Wheel
12
2
Figure 1
2. Lug nuts
1