Greasing And Lubrication - Toro 266H Wheel Horse 72052 Operator's Manual

Type: Champion RC-12YC (or equivalent)
Air Gap: 0.040 (1.02 mm)
Removing the Spark Plug
1. Disengage the power take off (PTO), set the parking
brake, and turn the ignition key to off. Remove the
ignition key.
2. Open the hood.
3. Pull the wire(s) off the spark plug(s) (Fig. 25). Now
clean around the spark plug(s) to prevent dirt from
falling into the engine and potentially causing damage.
4. Remove the spark plug(s).
Figure 25
1. Spark plug wire
Checking the Spark Plug
1. Look at the center of the spark plug(s) (Fig. 26). If you
see light brown or gray on the insulator, the engine is
operating properly. A black coating on the insulator
usually means the air cleaner is dirty.
Important
Never clean the spark plug(s). Always
replace the spark plug(s) when it has a black coating,
worn electrodes, an oily film, or cracks.
2. Check the gap between the center and side electrodes
(Fig. 26). Bend the side electrode (Fig. 26) if the gap is
not correct.
(s)
2
1
1218
2. Spark plug
25
2
1
Figure 26
1. Center electrode insulator
2. Side electrode
Installing the Spark Plug
1. Install the spark plug(s). Make sure the air gap is set
correctly.
2. Tighten the spark plug(s) to 20 ft-lb (27 Nm).
3. Push the wire(s) onto the spark plug(s) (Fig. 25).
4. Close the hood.

Greasing and Lubrication

Service Interval/Specification
Grease the machine after every 50 operating hours or
yearly, whichever occurs first. Grease more frequently
when operating conditions are extremely dusty or sandy.
Grease Type: General-purpose grease.
How to Grease
1. Disengage the power take off (PTO), set the parking
brake, and turn the ignition key to off. Remove the
ignition key.
2. Clean the grease fittings with a rag. Make sure to
scrape any paint off the front of the fitting(s).
3. Connect a grease gun to the fitting. Pump grease into
the fittings until grease begins to ooze out of the
bearings.
4. Wipe up any excess grease.
3
0.040in.
(1.02 mm)
3. Air gap (not to scale)
(s)