Nokia N8-00 Service Manual page 24

7) Press the SUB PWB carefully with the SS-93. Make
sure the two clips shown are locked.
9) Insert the two FIXING NUTS.
11) Hold the FIXING NUTS in place with your finger.
Tighten the two TORX + size 4 screws until the FIXING
NUTS stay in place. Do not tighten them completely!
If the screws are tightened too much the BOTTOM
COVER cannot be assembled.
24
8) Place the PROXY SENSOR BOOT with the tweezers
and press it down to activate the adhesive.
10) Note that there are two different TORX+ size 4
screw heads used in this device. The first two screws
are countersunk heads.
12) Place the FLASH MODULE with the tweezers.
Conf idential | Copyright © 2011 Nokia | A ll rights reserved
Nokia N8-00
RM-596
Service Manual Level 1&2
Version 6.0