Realignment - Kenwood TK-290 Service Manual

TK-290
9. Data Programming (PC Mode)
9-1. Preparation and Connection
TK-290 transceiver is programmed by using a personal
computer, programming interface cable KPG-36, and pro-
gramming software KPG-38D.
The programming software can be used with an IBM-PC
or compatible machine. Figure 3 shows the setup for pro-
gramming.
9-2. Programming Interface Cable KPG-36 Description
The KPG-36 is required to interface TK-290 to the com-
puter. It has a circuit in its D-sub 25pin connector case that
converts RS-232C logic level to TTL level.
KPG-36 is used to connect between TK-290 universal
connector and RS-232C serial port of computer.
9-3. Programming Software KPG-38D Description
KPG-38D is the programming software for TK-290 sup-
plied on a 3.5" floppy disk. This software runs under MS-
DOS version 3.1 or later on an IBM-PC/XT, AT, or PS2 or
compatible machine.
The data can be input to or read from TK-290 and edited
on the screen. The programmed or edited data can be
printed out. It is also possible to tune the transceiver.
We recommend that install KPG-38D for example to
harddisk first then use it.
KPG-38D instruction manual part No. : B62-0814-XX.
IBM-PC
KPG-38D
10
OPERATING FEATURES / REALIGNMENT
KPG-36
Fig. 3

REALIGNMENT

1. Mode
User mode
PC mode
Self programming mode
Panel test mode
Firmware programming mode
Mode
User mode Customer use this mode
PC mode Communication between the radio
and PC (IBM compatible).
It requires the KPG-38D
PC programming mode Frequency, signalling and features
write to the radio and read from
the radio.
PC test mode Check the radio using the PC.
This feature is included in the FPU.
Self programming mode Frequency, signalling and features
write to the radio.
Panel test mode Dealer use to check the fundamen-
(Refer to Adjustment) tal characteristics.
Firmware programming mode Re-write the firmware of the flash
ROM.
2. How to Enter Each Mode
Mode
User mode Power on
PC mode Power on begins the USER MODE.
Self programming mode Hold down the [Side 1] key and the
[Side 2] key, turn the radio power
on.
Panel test mode Hold down the [Side 2] key and
[PTT], turn the radio power on, and
release [PTT] first.
Firmware programming mode Held down the [Side 2] key and
[PTT], turn the radio power on, and
release [Side 2] key first.
PC programming mode
PC test mode
PC tuning mode
Channel setting mode
Group setting mode
Function setting mode
Clone master mode
LCD all lamp mode
Panel tuning mode
Clear function
Function
Operation