Page 1
SVR‐6400 Quick Start Guide The purpose of this quick guide is to help you configure the NVR model SVR‐6400. General The unit has three 1GB x network cards (Figure 1) 1 x for a Monitor 1 x for a Source (receiving IP streams) 1 x connecting to an external storage devise (NAS). The SNR set up is divided into two sections: 1. Basic configuration via the front LCD pane (Figure 2); 2. Full configuration via internal web server (Monitor Port IP Address). ...
Front LCD panel Figure 1. Figure 2. Basic Configuration Add power to the unit using the Power button on the rear panel (Figure 1), Use the down arrow on the front panel to find and select the Network Setup menu(Figure 3) then click ENTER. Figure 3. Figure 4. ...
Page 3
Full configuration Once the Monitor IP address is set, open Internet Explorer and open an IP session over http (port 80) as detailed below, User and Password are the defaults (USER: admin, PWD: 11111111). (Figure 7) Figure 7. Select the CONFIG TAB and then TIME SETUP to set up the TIME configuration as in Figure 8 and click APPLY. Figure 8. ...
Page 4
Select the CONFIG TAB and then NETWORK SETUP to configure the IP address for the Source ETH PORT before the Storage ETH PORT IP address all the parameters as shown in Figure 9 then click APPLY. Figure 9. Select CAMERA SETUP TAB under the CONFIG TAB. Add a new camera to the system as shown in the example in Figure 10 and click APPLY. Figure 10. ...
Page 5
Select the RECORD SETUP TAB in the CONFIG TAB and set up the parameters as shown in the example in Figure 11 and click APPLY. Figure 11. With the unit now recording, it is possible to see LIVE pictures from the cameras using the Monitoring Menu and recorded video using the Playback Menu. ...