Bosch ALS 25 Original Instructions Manual page 13

OBJ_BUCH-1436-002.book Page 13 Thursday, May 22, 2014 11:35 AM
 We recommend that this equipment
is only connected into a socket
which is protected by a circuit-
breaker that would be actuated by a
30 mA residual current.
 Only use or replace power supply
cables for this unit which corre-
spond to the types indicated by the
manufacturer. See the operating in-
structions for the order no. and
types.
 Never touch the mains plug with wet
hands.
 Do not run over, crush or pull the
power supply cable or extension
lead, otherwise it may be damaged.
Protect the cable from heat, oil and
sharp edges.
 The extension lead must have a
cross section in accordance with the
operating instructions and be pro-
tected against splashed water. The
connection must not be in water.
Electrical Safety
 Motor Protector fitted! Motor fit-
ted with safety overload protec-
tion. If motor stops working, allow
a few minutes to cool, before re-
starting.
 Warning! Switch off, remove plug
from mains before adjusting,
cleaning or if cable is entangled.
 If a cord becomes damaged dur-
ing use, disconnect the supply
cord from the mains immediately.
DO NOT TOUCH THE CORD BE-
FORE DISCONNECTING THE SUP-
PLY.
Bosch Power Tools
Your machine is double insulated for
safety and requires no earth connec-
tion. The operating voltage is 230 V AC,
50 Hz (for non-EU countries 220 V,
240 V as applicable). Only use ap-
proved extension cables. Contact your
Bosch Service Centre for details.
Extension cords/leads should only be
used if they comply with H05VV-F,
H05RN-F types or IEC type design
(60227 IEC 53, 60245 IEC 57).
If you want to use an extension cable
when operating your product, only the
following cable dimensions should be
used:
2
– 1.0 mm : max. length 40 m
2
– 1.5 mm : max. length 60 m
2
– 2.5 mm : max. length 100 m
Note: If an extension cable is used it
must be earthed and connected
through the plug to the earth cable of
your supply network in accordance
with prescribed safety regulations.
If in doubt contact a qualified electri-
cian or the nearest Bosch Service Cen-
tre.
 WARNING! Inadequate extension
cables can be dangerous. Exten-
sion cable, plug and socket must
be of watertight construction and
intended for outdoor use.
It is recommended for increased elec-
trical safety to use a Residual Current
Device (RCD) with a tripping current of
not more than 30 mA. Always check
your RCD every time you use it.
The connection lead must be inspected
for signs of damage at regular intervals
and may only be used if in perfect con-
dition.
English | 13
F 016 L81 128 | (22.5.14)