Unpacking And Setting Up; Operating The Appliance - Silvercrest SEAD 1800 B1 Operating Instructions Manual

RP89015 Einkochautomat LB2 Seite 53 Freitag, 22. Februar 2013 4:13 16
• Only place the appliance on a level,
dry, non-slip surface so that the
appliance can neither fall over nor slide
off.
• Do not place the appliance immediately
underneath a suspended cupboard, as
Note: As the appliance is supplied with a
thin film of grease, there might be a small
amount of smoke and odour the first time it is
used. This is not harmful and will stop after a
short time. Please
ventilation during this process.
1. Remove the individual parts from the
packaging.
2. Check that the individual parts are
complete (see "1.2 Scope of supply" on
page 49) and are undamaged.
3. Clean the appliance thoroughly before
using it for the first
"9. Cleaning and storing" on page 59).
6.1 Adjusting settings, switching on and
off
Note: As soon as you turn the rotary
knobs 7 or 6, the background illumination
for the displays will switch on automatically.
The light for the displays switches off again
automatically after 5 minutes.
Warning! Only connect the
appliance to an earthed mains
socket, as
electric shock depends on this.
SEAD 1800 B1
• Do not place the appliance on a hot
• The appliance and accessories may not

5. Unpacking and setting up

4. Unwind the mains cable 8 from the
5. Place the appliance on a level, dry, non-
ensure adequate
6. Insert the power supply plug in a
7. Add around 5 l water to the container 3.
8. Allow the water to boil for around 20
time (see
9. Pour the water away.
The appliance is now ready to use.

6. Operating the appliance

1. Insert the power supply plug in a
2. Turn
protection against
steam escapes upwards and might
damage the furniture.
cooking ring.
be put in a microwave oven.
cable store over its entire length.
slip surface so that the appliance can
neither fall over nor slide off.
suitable earthed mains socket (see
"3. Technical data" on page 50).
min (see "6. Operating the appliance"
on page 53).
suitable earthed mains socket (see
"3. Technical data" on page 50).
the rotary knob
temperature 6 to the temperature you
require.
– The temperature is increased in
increments of 1 °C;
– A signal sounds every 5 °C;
– The temperature selected is shown on
the display for
selection 10.
for the
temperature
53