Cleaning And Care; Housing - Miele DA 3160 Operating And Installation Instructions

,
Before any cleaning or
maintenance work is carried out,
disconnect the rangehood from the
mains supply.
Ensure that:
– it is switched off at the wall socket
and the plug is withdrawn, or
– the mains fuse is disconnected ,or
– the screw-out fuse is removed
(in countries where this is
applicable).
,
Exercise caution when changing
halogen lamps. They get very hot
during use, and remain hot for some
time after being switched off. Do not
touch the surface directly when
changing a lamp, as grease particles
from your fingers will adhere to the
surface and damage it.
The halogen lamps can also be
damaged if water is used to clean
them.
Wait several minutes after switching
off before beginning cleaning.
A range of Miele branded cleaning and
conditioning agents are available to order
through your Miele Chartered Agent, from
Miele or via the internet at
www.miele-shop.com (check availability).

Housing

General notes
Warning: The surfaces and controls
are susceptible to scratches and
abrasions. Please observe the
following cleaning instructions.

Cleaning and care

^ All external surfaces and controls can
be cleaned using the Original Miele
all purpose microfibre cloth or warm
water with a small amount of
washing-up liquid applied with a well
wrung-out soft sponge or cloth.
^ Wipe the surfaces dry using a soft
cloth.
Do not use too much water when
cleaning the controls. Water could
penetrate into the electronics and
cause damage.
Do not use:
– cleaning agents containing soda,
acids, chlorides or solvents,
– abrasive cleaning agents, e.g.
powder cleaners or cream cleaners
and abrasive sponges, as well as pot
scourers or sponges which have
been used previously with abrasive
cleaning agents. These will damage
the surface material.
Important for appliances with
stainless steel housing
(This infomation does not apply to the
controls)
Stainless steel surfaces can be cleaned
with a proprietary non-abrasive cleaning
agent designed specifically for use on
stainless steel.
To help prevent re-soiling, a
conditioning agent for stainless steel
can also be used. Follow the
instructions on the label, and apply
sparingly with an even pressure in the
direction of the "grain".
15