Specifications - Hitachi SB-110 Handling Instructions Manual

English
PRECAUTIONS ON USING BELT SANDER
CAUTION
Prior to the sanding operation, make sure the
material you are going to sand.
If generation of harmful/ toxic dusts such as lead
paint, woods and metals is expected under the

SPECIFICATIONS

Model
Voltage (by areas)*
Power input*
No–load belt speed
Sanding belt size
Weight (without cord)
* Be sure to check the nameplate on product as it is subject to change by areas.
** 100 × 610mm sanding belts can also be attached to this belt sander.
STANDARD ACCESSORIES
(1) Endless sanding belt (Grain size: #80) ................ 1
(2) Dust bag .................................................................... 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES
(sold separately)
1. Endless sanding belts
Table1
Grain size
30
40
60
80
100
120
150
180
240
320
400
NOTE:
The endless sanding belt is sold in package of 10
belts of the same type. When ordering, specify the
grain type and grain size desired.
2. Stationary Stand
When sanding small articles, use a stationary stand
for convenience.
Optional accessories are subject to change without notice.
5
SB-110
High Speed Low Speed
(110V, 120V, 127V, 220V, 230V, 240V)
950 W*
350 m / min 300 m / min
110 × 620 mm**
7.3 kg
Grain Type
AA, CC
AA, WA, CC
AA, WA, CC
AA, WA, CC
AA, WA, CC
AA, WA, CC
AA, WA, CC
AA, WA, CC
AA, WA, CC
AA, CC
AA, CC
sanding operation, make sure the dust bag or
appropriate dust extraction system is connected
with dust outlet tightly.
Wear the dust mask additionally, if available.
Do not inhale or touch the harmful / toxic dusts
generated in sanding operation, the dust can
endanger the health of yourself and bystanders.
High Speed
860 W* 950 W*
450 m / min
APPLICATIONS
Finish sanding and finish flooring of woodwork
products.
Base polishing of wood-coated surfaces.
Finish sanding of metal surfaces.
Base polishing of metal-coated surfaces, rust
removal, or paint removal prior to refinishing.
Surface finishing of slate, concrete, and similar
materials.
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specified on the product
nameplate.
2. Power switch
Ensure that the power switch is in the OFF position.
If the plug is connected to a receptacle while the
power switch is in the ON position, the power tool
will start operating immediately, which could cause
a serious accident.
3. Extension cord
When the work area is removed from the power
source, use an extension cord of sufficient thickness
an rated capacity. The extension cord should be
kept as short as practicable.
4. Attach the sanding belt
For details, refer to the section on "Sanding Belt
Assembly".
PRACTICAL OPERATING PROCEDURES
1. Adjusting the Sanding Belt position
Pull the switch and turn the sanding belt to the
check position.
SB-75(B)
Low Speed
670 W*
360 m / min
76 × 533 mm
4.4 kg