Nokia 12 GSM MODULE REMOTE I/O Control Manual page 43

Table 12. Output_Pulse X commands
Command Type Command
Output_Pulse X On
Response:
Response, when pulse time expires:
The X refers to output pin number, X=
1,2,3,4,5,6,7,8,9,all.
The Y refers to either ON or OFF.
Response, if another pulse command has already been
issued:
Fail response, if invalid <time> value:
Fail response, if NITZ network service is not supported
and <time> value was more than 23 hours 59 minutes
and 59 seconds:
Output_Pulse X Off
Response:
Response, when pulse time expires:
Response, if another pulse command has already been
issued:
Fail response, if invalid <time> value:
term123 Output_Pulse X
On <time>
OUTPUT_PULSE X ON
<time>: OK
OUTPUT X: Y
OUTPUT_PULSE X ON
<time>:
OUTPUT X LOCKED
ERROR( Unknown Command )
OUTPUT_PULSE ON <time>:
ERROR( Network Time
Missing )
term123 Output_Pulse X
Off <time>
OUTPUT_PULSE X OFF
<time>: OK
OUTPUT X:Y
OUTPUT_PULSE X OFF
<time>:
OUTPUT X LOCKED
Comments
The command sets to
output pin X on for a
requested time interval,
that is, pulse
The command sets to
output pin X off for a
requested time interval,
that is, pulse
39/49