Nokia MW1122 User Manual page 5

MW1122 User Manual
STA
RED
Off OK
On Hardware malfunction during startup.
PWR GREEN
Off Power off.
On Power on.
2.3 Step-by-step installation procedure
1. Plug the mains power cord to a mains outlet.
2. Plug the antenna into the antenna connector of the wireless LAN
card, if included.
3. Insert the wireless LAN card, if included, gently into the MW1122
WLAN slot on the MW1122 back panel. Ensure that the card is
aligned correctly.
4. Switch on MW1122. The PWR indicator lights up.
5. Ensure that wireless LAN clients (that is, the wireless devices you
want to use in your network) have the same configuration as the
wireless LAN card in the MW1122 modem and that they are in the
Infrastructure mode. The default wireless LAN configuration of
MW1122 is the following:
regulatory-domain according to your location of use (Europe,
network name
When you have set the network name to your wireless client, the
wireless connection is established and the WLAN indicator on
MW1122 fron panel will be lit.
6. Connect the 8-pin Ethernet cable between your PC and the
Ethernet connector on the MW1122 back panel if you want use a
PC equipped with a 10Base-T Ethernet card. Switch on your PC.
The ETH indicator will be lit.
4
Canada, USA, or Japan)
MW-wxyz (case-sensitive), where wxyz are
the last four numbers from your MW1122
serial number
E Copyright Nokia Networks Oy
C33902002SE_00