Canon dp-v3010 Instruction Manual page 79

Operation Invalid operation.
"Protect Settings" is on.
"CDL Override" is on.
"Knob Lock" is on.
USB memory USB memory is not connected.
Unsupported USB memory.
Message Description and Action
F buttons will not function in the following cases:
• When the following function is set during
DisplayPort signal selection:
- H Delay/V Delay
- Time Code
• When the following function is set while "Input
Configuration" is not performed for the selected
channel:
- Time Code
• When the following function is set while "H
Delay"/"V Delay" is set:
- Screen Scaling
- Aspect Marker
- Safety Zone Marker
- Peaking 1/Peaking 2
• When the following function is set while
"Peaking 1"/"Peaking 2" is set:
- Aspect Marker
- Safety Zone Marker
- Center Marker
- Grid Marker
- H Delay/V Delay
- Time Code
To use the OSD menu, move the selection frame
to "Protect Settings" and press the SET button for
approximately 3 seconds.
When "CDL Override" is turned "On", you cannot
adjust the "POWER", "SATURATION", "OFFSET", or
"SLOPE".
If the knobs are not functioning, please set "Knob
Lock" to "OFF".
Correctly connect the USB memory to the USB port
of this main unit.
Check the USB memory format and make sure it is
not protected.
Error Messages 79