Sharp AR-FX12 Service Manual page 39

B. Details
SW Bit Item
No. No.
1 1-8 Country code
2 1 TSI judgment setting
when a certain number
receive reject
(No signal or all space)
2 Specified number
receive rejection setup
(FAX)
3 Manual receive mode
receive rejection setup
(FAX)
4 Manual receive mode
auto receive switch
setup
5-8 Number of calls to
switch to auto receive in
manual receive
3 1 Not used
2 External telephone
connection
3 Default finish stamp
4 Not used
5-8 Number of calls for auto
receives
4 1,2 Not used
3 Polling protection
4 Relay data output
Switch selection and function
Country code set by ITU-T. Control is made according to the set country code.
Used to set receive reject or receive allow when there is no TSI signal from the
remote machine or when the TSI signal is all space, when a certain number
receive reject is set to valid by the key operation.
1: Receive reject
Used to set whether a certain number receive reject by FAX is Enabled or
Disabled. In auto receive only.
1: Specified number
receive rejection (Valid)
Used to set whether a certain number receive reject by FAX is Enabled or
Disabled. In manual receive only.
1: Specified number
receive rejection
Used to set whether auto receive switch is performed or not in the manual
receive mode.The number of switching to auto receive is set with SW2-5-8.
1: Allow(Switched)
Used to set the number of calls to switch to auto receive in manual receive
mode.
This function is valid only when SW2-4 is set to "1: Allow (to switch)." If a value
outside the set range is inputted, the default setup is made.
Setting to use an external telephone. If not set to YES, an external telephone
cannot be used.
1: External telephone YES 0: External Telephone NO
In North America, users cannot set this switch to "0: NO."
Used to set whether the finish stamp is used or not after completion of
document scan when the SPF/RSPF is used.
1: Finish stamp used
If a document feed unit other than the SPF/RSPF is used, this setup is invalid.
Used to set the number of calls to start auto receive (to catch the line). Setup is
made in the range of 0 ~ 15 by binary input.
When set to 0, no ringing is made. For the nighttime FAX mode (main SW OFF,
memory SW ON), however, ringing of an external telephone is made.
Used to set Enable/Disable of confidential protection (inhibition of transmission
to erroneous party) in transmission of bulletin board. Confidential protection is
made by collating the number registered in this machine and that in the other
party machine. Sender's number and send request allow number are collated
each other. In this machine, Sharp's unique collating of system number
ID number is not performed.
1: Not protected
Used to set whether the document received from the relay station is outputted
or not when relay broadcast reception is made.
1: Document received
from relay station is not
outputted.
Similar to F code relay broadcast indicating reception.
AR-FX12 SIMULATIONS, FAX SOFTWARE SWITCH 6-27
0: Receive allow
0: Specified number
receive ignored (Invalid)
0: Specified number
receive ignored(OFF)
0: Inhibit (Not switched)
0: Finish stamp not used
0: Protected
0: Document received
from relay station is
outputted.
USA Initial value Key
operator
1 North
America
0
1
1
0
1
0
1
0 Receive
allow
0 Specified Receive
number setup
receive
ignored
(Invalid)
0 Specified
number
ignored
0 Inhibit Receive
setup
1 9 Receive
setup
0
0
1
0
1 YES Initial setup
0 NO Operation
setup
0
0 2 Receive
setup
0
1
0
0
0
0 Protect Polling
security
setup
0 Output