Samsung SRP-275 Operator's Manual page 20

CHAPTER 3
Switch settings
Default Settings
The default settings for Memory Switch 0 (MSW 0) to Memory Switch 8 (MSW 8) are shown below.
Settings vary for single byte character countries (standard specifications (SBCS)) and for double-byte
character countries (Chinese character specifications (DBCS)).
Standard specifications (SBCS)
Memory Switch Number
MSW0
MSW1
MSW2
MSW3
MSW4
MSW5
MSW6
MSW7
MSW8
Chinese character specifications (DBCS) (For China)
Memory Switch Number
MSW0
MSW1
MSW2
MSW3
MSW4
MSW5
MSW6
MSW7
MSW8
3-12
Ex-factory Settings (n1, n2, n3, n4)
"0000"
"0000"
"0000"
"0000"
"0000"
"0000"
"0000"
"0000"
"0000"
Ex-factory Settings (n1, n2, n3, n4)
"0010"
"0000"
"0000"
"0000"
"0000"
"0000"
"0000"
"0000"
"0000"
Function
Memory Switch 0
Bit Function
F~C Reserved
Red and black
B (inverted black and white)
Commands
Red and black
A (inverted black and white)
Commands
9~5 Reserved
4 Country specifications (*1)
3 <FF> Command Function selection
2 <FF> Command Function selection
1 Reserved
0 Reserved
(*1) Country Specifications
Country MSW0-4 = 0
Overseas Standard Specifications
(*2) <FF> Command Function Selection
Country Country <FF> Command Function
Auto cutter Model
0 0 Executes a form feed.
After paper fed to cutting position
0 1
Executes partial cut.
1 0 Executes a form feed.
After paper fed to cutting position
1 1
Executes partial cut.
0 1
See table below (*3)
See table below (*3)
SBCS DBCS
(Single Byte Countries) (Double Byte Countries)
See table below (*2)
See table below (*2)
MSW0-4 = 1
Chinese Characters
<FF> Command Function
Tear Bar Model
Executes a form feed.
Paper fed to the tear-bar
position.
Executes a form feed.
Paper fed to the tear-bar
position.
3-13