StarBoard FX-79E1/89WE1
1.4.3 Equipment Connection Method
Before Starting to Connect Equipment
Install the StarBoard Software on your PC before starting to connect equipment. The
equipment might not operate correctly if it is connected without the software being
installed.
Connect the PC, projector and StarBoard according to the following procedure.
(3)
(1) Connect the RGB cable to the projector's RGB connector, and fasten with screws.
(2) Connect the opposite side of the RGB cable to the PC's RGB connector, and fasten with
screws.
(3) Connect the USB connector at the bottom left of the StarBoard to the USB port on the PC
using the provided USB cable.
(4) Connect the power supply cables of the PC and projector to the power supply.
NOTICE
Do not touch board at the time of plugging USB cable.
It may cause of malfunction.
StarBoard
(3)
(2)
PC
1-14
Introduction
(1)
Projector
(4)
(4)
Power Supply
English