Samsung MIM-H03UN User & Installation Manual page 7

How to install Wi-Fi kit
3 . After fixing the rear cover of a Wi-Fi kit firmly into the wall with two or more screws, connect the power wire (V1, V2) and
communication wire (F1, F2) to the terminal at the back side of the front cover with proper length .
When connecting the V1 and V2 power, tighten the screw of the terminal block (CN5) with torque 5 ±2 Kgf·cm .
The size of the screws is 3 x 6 .
• Maximum number of indoor unit installation that can be connected to Wi-Fi kit is 16 .
• One Wi-Fi kit can be registered with maximum 5 users .
NOTE
• Each account (one mobile phone) can be registered with maximum 2 Wi-Fi kits .
10 mm
(9/16 inch) or more
10 mm
(9/16 inch) or
more
50 mm (2 inches)
or more
❋ ❋ Before fixing the rear cover, allow
10mm or more space for upper,
left, and right sides and 50mm
space for bottom side .
Item
Ⓐ
Power/communication connection terminal
Ⓑ
Tracknig/Initializing button
Ⓒ
SD Card Slot
Ⓓ
LED
❋ ❋ If an indoor unit does not have V1 and V2 terminal block, use the exterior control 2-wire for SUB PBA which is placed
inside the Wi-Fi kit to supply power to the Wi-Fi kit .
Connect the BLK wire to V2 .
6
CAC Wifi APP-NA_IBIIM_EN_DB68-05417A-00.indd 6
10 mm
(9/16 inch) or more
Screw
fixing
hole
Rear cover
❋ ❋ Fix the screws in the
provided screw holes .
Contents
BLK
Indoor unit
V1 V2 F1 F2
❋ ❋ Do not tighten the PCB terminal with
too much force .
ORG
Connect the ORG wire to V1 .
2015-03-16 오후 2:21:45
Ⓑ
Wi-Fi kit
Ⓓ
Ⓒ
Ⓐ
PCB
terminal