Place silica gel (supplied)
Locking the Camera
Depending on the material of your mounting surface, you may require different
Note
screws and anchors than those supplied.
If tilt angle is less than 25 degrees from the horizontal, the image can flash by
reflection of IR-LED light. Keeping tilt angle over 20 degrees is recommended
Note
when IR-LED light is used.
Please pick up and tear off the silica gel package from accessory.
After adjusting images, place the silica gel at the position shown in the diagram
below.
Fix the silica gel to the position so it will not fall off.
Use soft, lint -free cloth to wipe the dome cover clean and remove fingerprints.
Turn the power on after you have installed the camera.
Silica gel
Inserted space
9
Silica gel