NEC PowerMate ES Series Configuration Manual

409-00072-000 6/7/00 11:30 AM
PowerMate ® ES Series System Board Configuration
Jumper Settings
JP2
USB Factory setting.
3
Keyboard Disables system
2
1
Wakeup wakeup by USB
keyboard.
Keyboard JP1 Factory setting.
at Disables keyboard at power on.
1 2 3
Power On
JP1
Enables keyboard
at power on.
1 2 3
JP3
Save to Factory setting.
RAM Enables Suspend
mode Save to RAM
(STR) function.
USB Port Factory setting.
JP13
3 2 1
Selection Enables front
USB port and
6 5 4
rear USB port.
JP19
CMOS Factory setting. Maintains system board
1
Clear 2 configuration in CMOS RAM with onboard
3
battery.
JP19
Clears CMOS while system power is off.
1
Return jumper to pins 2 and 3 before
2
3 powering system on.
Caution: To prevent damage to the system board,
avoid clearing CMOS while power is on.
JP15
BIOS Factory setting. Sets the system for
1
Recovery normal operation. The BIOS uses current
2
3
configuration information and passwords
at power on.
To enable BIOS recovery for a corrupted
system, remove the jumper. Wait 10 seconds.
Replace the jumper on pins 1 and 2.
JP15
Restores Safe BIOS settings as the
1
default BIOS settings and loads the
2
3
BIOS Setup at power on.
Website: www.nec-computers.com
Technical Support: 800-632-4525
Page 1
JP2
Enables system
3
2 wakeup by USB
1
keyboard.
Note: See your PowerMate ES Series User's Guide
for detailed option installation information.
Memory Upgrade
Maximum memory supported: 512 MB;
minimum memory required: 32 MB.
Memory type and size can vary between sockets.
System supports 168-pin, 100-MHz non-ECC SDRAM modules
JP3
in 32-MB, 64-MB, 128-MB, and 256-MB configurations.
Disables Save
Use NEC memory upgrade kits for the best compatibility with your
to RAM function.
system. For memory compatibility information, call Technical Support.
Single- or double-sided DIMMS are supported.
No jumper setting required.
Disables front
JP13
3 2 1
USB port and
Processor Upgrade
enables rear
See your user's guide for detailed processor upgrade information.
6 5 4
USB port.
JP15
Jumper
JP19
Jumper
Processor Socket 370
PCI Slots
JP13 Primary
Jumper
IDE Connector
Secondary
IDE Connector
JP2
Jumper
JP1
Jumper
System
Memory
Upgrade
Sockets
JP3
Jumper
409-00072-000