Fax Over Ip Codec Setup - NEC SL1100 Programming Manual

ISSUE 6.0
Program 84 : Hardware Setup for VoIPDB
Level:
IN
(This Program is available for V4.0 or higher)
Description
Use Program 84-32 : FAX Over IP CODEC Setup to program the CODECs used when faxing across
SIP Trunk. Note these settings must match in both systems for faxing across SIP Trunk to work.
Input Data
Type
(V5.0 Added)
Item Item
No.
01 FAX CODEC
02 Payload Size
03 Jitter Buffer Mode
04 Jitter Buffer (min)
05 Jitter Buffer (average) 0 ~ 300
06 Jitter Buffer (max)
Programming Manual

84-32 : FAX Over IP CODEC Setup

Input Data
1 = G.711 a-law Set up FAX over IP CODEC.
2 = G.711 u-law
3 = G.726
(SIP Profile:1-2) (V5.0
Added)
When the G.711 a-
law is selected in
Item 01, it is possi-
ble to set "8".
When the G.711 u-
law is selected in
Item 01, it is possi-
ble to set "0".
When the G.726 u-
law is selected in
Item 01, it is possi-
ble to set "2". (V5.0
Added)
1 ~ 4 (10 ms base) Set up payload size when using SIP Trunk.
(SIP Profile:1-2) (V5.0
Added)
1 = Static Set up Jitter Buffer settings when using
2 = Self adjusting SIP Trunk.
(SIP Profile:1-2) (V5.0
Added)
0 ~ 300 Set up minimum Jitter Buffer settings when
(SIP Profile:1-2) (V5.0 using SIP Trunk.
Added)
Set up average Jitter Buffer settings when
(SIP Profile:1-2) (V5.0 using SIP Trunk.
Added)
0 ~ 300 Set up maximum Jitter Buffer settings
(SIP Profile:1-2) (V5.0 when using SIP Trunk.
Added)
1 = Reserved
2 = SIP Trunk Profile 1
3 = SIP Trunk Profile 2
4 = Reserved
Description
SL1100
Program
84
Default
2
2
1
20
40
80
2-529