Panasonic EY7880 Operating Instructions Manual page 12

How to charge
1. Plug the charger into the AC outlet.
NOTE:
Sparks may be produced when the
plug is inserted into the AC power
supply, but this is not a problem in
terms of safety.
2. Connect the battery pack firmly in-
to the charger.
1 Line up the alignment marks and
place the battery onto the dock
on the charger.
2 Slide forward in the direction of
the arrow.
3. During charging, the charging lamp
will be illuminated.
When charging is completed, an in-
ternal electronic switch will automat-
ically be triggered to prevent over-
charging.
• Charging will not start if the battery
pack is warm (for example, immedi-
ately after heavy-duty operation).
The orange standby lamp will be
flashing until the battery cools down.
Charging will then begin automatically.
!EY7880(EU).indb 12 !EY7880(EU).indb 12
Alignment marks
- 12 -
4. The charge lamp (green) will
flash slowly once the battery is
approximately 80% charged.
5. When charging is completed, the
charging lamp in green color will
turn off.
6. If the temperature of the battery pack
is 0°C or less, charging takes long-
er to fully charge the battery pack
than the standard charging time.
Even when the battery is fully
charged, it will have approximately
50% of the power of a fully charged
battery at normal operating temper-
ature.
7. Consult an authorized dealer if the
charging lamp (green) does not turn
off.
8. If a fully charged battery pack is in-
serted into the charger again, the
charging lamp lights up. After sev-
eral minutes, the charging lamp in
green color will turn off.
9. Remove the battery pack while the
battery pack release button is held
up.
2013-11-27 17:03:10 2013-11-27 17:03:10