Table of Contents
Advertisement
Consider the following when installing the rails:
Installing the rails does not require any tools for assembly.
HP recommends that you install all the rail kits before installing any other components.
Ensure that the rails are level before installing any other components.
WARNING!
Before you begin, ensure that the rack is sufficiently stable. If provided, lower the
rack leveler feet and make sure any required stabilizers are installed. If provided, extend the anti-tip
device. Failure to extend the anti-tip device could cause personal injury or damage if the rack tips
over.
1.
On the rear of the rail, squeeze the scissor latch (1,
rail and pins through the rack holes (2) until the latch engages.
Figure 5 Attaching the rear rail
2.
On the front of the rail, pull the locking latch to release the scissors latch (1,
14)) and squeeze the scissors latch together to insert the rail and pins through the rack upright
holes (2) until the latch engages (3).
Figure 5 (page
13)) together to insert the
Figure 6 (page
Attach the rails
13
Advertisement
Table of Contents
