Kenwood AT910 Instruction Manual page 11

Question
The feed tube keeps blocking
The cutting assembly is difficult
to remove
The cutting assembly is difficult
to fit
Answer/Hint
Add small amounts of pasta at a time
●
in a steady rate and only add more
when the feed tube is clear.
The mix is too wet.
●
Use the end of the spanner/pusher to
●
push the mix down the feed tube.
(Removing the hopper will enable the
spanner to reach lower down the feed
tube).
Vary the speed of adding the mix.
●
Leave the attachment to cool down
●
for approximately 30 minutes.
Make sure the metal clamp ring is
●
partially unscrewed from the plastic
inner before pushing onto the
attachment.
8