Panasonic EY7442 Service Manual page 13

Ref. No. 2H-2 Procedure 2A → 2B → 2C → 2D → 2E → 2F→
2G → 2H
Procedure 2A → 2B → 2C → 2D → 2E → 2F→
Ref. No. 2I
2G → 2H→ 2I
Assembly of Adjusting screw and Clutch handle.
for EY7950
1. Hold the driving block with the click spring on top, and align the
mark of adjusting screw with the bottom of the clutch case.
NOTE:
Make sure that the adjusting screw has its own correct direction
for proper assembly. Failure to do so, the clutch handle does not
rotate properly.
2. Turn the adjusting screw into the driving block about one rotation
for clockwise direction.
3. Set the clutch handle with position 14 on top.
(Align the projection of clutch handle on bottom.)
Attachment of H/L change handle.
1. Insert the both side of handle spring into the groove of Ring gear
A.
13