AUDIOGRAM3
DISASSEMBLY PROCEDURE(分解手順)
Precautions(注意事項)
During assembly, pay attention that connectors, cables or the like are not pinched by circuit boards, frames, etc.
●
組み立てるときは、基板やフレームなどでコード類をはさまないように注意してください。
●
1.
Top Cover Assembly
(Time required: About 1 minute)
1-1
Remove the four (4) screws marked [140]. The top
cover assembly can then be removed. (Fig. 1)
2.
MIX3 Circuit Board
(Time required: About 2 minutes)
2-1
Remove the top cover assembly. (See procedure 1.)
2-2
Remove the screw marked [120]. The MIX3 circuit
board can then be removed. (Fig. 2)
2-3
Pull out the three (3) volume knobs marked [100] and
two (2) push buttons marked [110] from the MIX3 cir-
cuit board. (Fig. 2)
*
The volume knobs and push buttons are not compo-
nents of the MIX3 circuit board.
When replacing the MIX3 circuit board, remove the
volume knobs and push buttons and install them on
the new MIX3 circuit board.
< Bottom view(底から見た図) >
[140]
x2
TOP COVER ASSEMBLY
(トップカバーAss' y)
[140]: BIND HEAD TAPPING SCREW(B タイト+ BIND)
3.0X12 MFZN2W3 (WE98740R)
6
[140]
x2
Fig. 1(図 1)
1.
トップカバー Ass'y
1-1
[140] のネジ 4 本を外して、トップカバー Ass'y を
外します。 (図 1)
2.
MIX3 シート
(所要時間:約 2 分)
2-1
トップカバー Ass'y を外します。 (1 項参照)
2-2
[120] のネジ 1 本を外して、MIX3 シートを外しま
す。 (図 2)
2-3
MIX3 シートの上面から、[100] のノブ V R (小)3
個と [110] のボタンH PF 2 個を外します。 (図 2)
※
ノブ VR (小) とボタンHPF は MIX3 シートの構成部品で
はありません。 MIX3 シートを交換する際は、 ノブ VR (小)
と ボタンHPF を取り外して新しい MIX3 シートに取り
付けてください。
[110]
x2
[100]
[120]
[100]
BOTTOM CASE
(ボトムケース)
[120]: BIND HEAD B-TIGHT SCREW(B タイト+ BIND)
3.0X8 MFZN2W3 (WE774300)
Fig. 2(図 2)
(所要時間:約 1 分)
[100]
MIX3