Drive Select Switch - Yamaha YDRE Owner's Manual

WARNING
To reduce the risk of accidents and injury or DEATH:
• Read the label located on the steering wheel before operation. • Drive slowly straight up and down slopes.
• Operate only when authorized and only in designated areas. • Set parking brake before leaving vehicle.
• Operate from driver's seat only. • Turn main switch to "OFF" and remove key when not in use.
• This vehicle is restricted to 2 occupants per bench seat. • Do not operate while under the influence of alcohol or drugs.
• Do not start vehicle until all occupants are seated. • maximum loading: 400lb (181kg) per bench seat 100lb (45kg) in bagwell.
• Remain fully seated and hold on when in motion.
• Keep entire body inside vehicle.
• Drive slowly in turns.
REV
8888.8
BATTERY
BAR LEVEL
VOLT
WARNING
To reduce the risk of accidents and injury or DEATH:
• Read the label located on the steering wheel before operation. • Drive slowly straight up and down slopes.
• Operate only when authorized and only in designated areas. • Set parking brake before leaving vehicle.
• Operate from driver's seat only. • Turn main switch to "OFF" and remove key when not in use.
• This vehicle is restricted to 2 occupants per bench seat. • Do not operate while under the influence of alcohol or drugs.
• Do not start vehicle until all occupants are seated. • maximum loading: 400lb (181kg) per bench seat 100lb (45kg) in bagwell.
• Remain fully seated and hold on when in motion.
• Keep entire body inside vehicle.
• Drive slowly in turns.
REV
8888.8
BATTERY
BEEP
JC1
FWD OFF ON ON
JC0-K7768-60
Y-2419
9 8 7
48.95 47.8 47.4 46.9 46.4 46.0 44.8 44.0 43.5
FWD OFF ON ON
JC0-K7768-60
Y-2408
Y-2409
CONTROLS
As the battery energy decreases,
the LEDs will move to the left toward
the "E." When the LED light below
the "E" is the only one lit, the
batteries must be charged.
Use the table to determine the
remaining battery capacity. For
example, if 7 of the 9 LED lights are
lit, batteries still have approximately
47.4 volts left. When the batteries fall
to 43.4 volts or less, 1 LED will blink
on and off, meaning the batteries
should be charged immediately.
6 5 4 3

DRIVE SELECT SWITCH

The drive select switch is used to
shift the PTV into forward or reverse.
After coming to a complete stop, move
the switch to the desired position.
Switch Position
FWD
REV
TIP
The reverse alarm will sound when
the drive select switch is depressed
to the "REV" position.
2 1 1 BLINK
43.4 >
Car Movement
FORWARD
REVERSE
5-3
1
2
3
4
5
6
7
8
9
10
11