Canon iPF6400S Basic Manual page 15

• The loading method for a printer with a Spectrophotometer Unit (option) is the same as for a
printer with no Spectrophotometer Unit (option). If it is difficult to perform operations from the
Note
front of the printer, lower the Up-down Unit. (See "Lowering the Up-down Unit of the
Spectrophotometer Unit (option) Manually.")➔P.19
1
Press the Load button.
Press ▲ or ▼ to select Roll Paper, and then press the OK button.
2
• If any paper has been advanced that will not be used, a message is shown requesting
Note
3 Open the Roll Feed Unit Cover.
4 Holding the Roll Holder flange (a), load the Roll
Holder shaft into the guide grooves (b) on both
sides of the Roll Holder Slot. At this time, load
the shaft so that the color of the Roll Holder shaft
(c) matches the color of the guide groove.
• Do not release the flanges until you load the holder fully in the Roll Holder Slot. Rolls
Caution
• Be careful not to pinch your fingers between the guide grooves (b) and the Roll Holder
you to remove it.
Press ▲ or ▼ to select Yes, and then press the OK button. Remove the paper and go
to the next step.
are heavy, and dropping a roll may cause injury.
shaft (c) when loading rolls.
iPF6400S Basic Guide
15